News Daily


Men's Weekly

Australia

  • Written by The Conversation
Labor slides in a federal Newspoll; NSW polls give Labor a modest lead

A federal Newspoll, conducted March 1-4 from a sample of 1,530, gave Labor a 54-46 lead, a one-point gain for the Coalition since the previous Newspoll in early February. Primary votes were 37% Labor (down one), 35% Coalition (up one), 10% Greens (down one), 7% One Nation (up one) and 11% for all Others (steady).

While the Coalition only gained one point on two party vote, the change in primary votes implies that the Coalition’s gains were greater, and that rounding saved Labor from a 53-47 Newspoll.

Prime Minister Anthony Albanese’s ratings dropped, with 55% satisfied (down two) and 38% dissatisfied (up five), for a net approval of +17, down seven points. Since the December Newspoll, Albanese has lost 16 points of net approval.

Opposition Leader Peter Dutton’s net approval was down one point to -11. Albanese led Dutton as better PM by 54-28 (56-26 in February). Newspoll figures are from The Poll Bludger.

By 64-29, voters approved of the proposed changes to super that would increase the tax rate from 15% to 30% for account balances above $3 million.

I agree with this article by Peter Brent in Inside Story: Labor would have been better off implementing the super changes in July 2024, not July 2025. Implementing them in 2024 would give the changes time to get bedded down before the next election, and for voters to get used to them. The 2025 implementation date will give the Coalition an opportunity for a scare campaign at the next election.

There is precedent for governments’ polling improving once a major change has been implemented, and the sky hasn’t fallen in. As Brent says, this applied to both the introduction of the GST in July 2000 and to the introduction of the carbon tax in July 2012.

Labor and Albanese’s current slide in the polls is probably much more due to high inflation and interest rates than policy issues.

Federal Morgan poll: 56.5-43.5 to Labor

In last week’s federal Morgan poll, conducted February 20-26, Labor led by 56.5-43.5, a two-point gain for the Coalition since the previous week. Primary votes were 37% Labor, 34.5% Coalition, 13.5% Greens and 15% for all Others.

NSW Resolve poll: Labor increases large lead

The New South Wales state election will be held on March 25. A Resolve poll for The Sydney Morning Herald, conducted February 22-26 from a sample of 803, gave Labor 38% of the primary vote (up one since January), the Coalition 32% (down two), the Greens 11% (down one), independents 13% (up one) and others 7% (up two).

Resolve did not give a two party estimate for this poll, but analyst Kevin Bonham estimated 56-44 to Labor, a one-point gain for them since January.

Independent support is almost certainly being overstated by Resolve, and it is likely they will crash back to something more plausible in the final Resolve poll, which will be based on actual lists of candidates after nominations close on Wednesday. A slump for independents occurred in both Victoria and federally close to elections.

Read more: Victorian Labor slumps in Resolve poll but still in winning position; Labor failure on upper house reform comes back to bite

Liberal Premier Dominic Perrottet had a 38-34 lead as preferred premier over Labor leader Chris Minns (33-29 in January). By 45-40, voters thought Perrottet had performed well in recent weeks, while for Minns this was a 43-28 good performance.

Since the 2022 federal election, Resolve has generally been more favourable to Labor than other pollsters in both its federal and state polls. This poll is far better for Labor than the NSW Freshwater and Morgan polls below and the NSW Newspoll that I covered last Monday. All these polls were conducted at about the same time in late February.

Read more: Labor's lead reduced in a NSW Newspoll four weeks before election; Voice support steady

NSW Freshwater poll: 53-47 to Labor

The Poll Bludger reported that a NSW Freshwater poll for The Financial Review gave Labor a 53-47 lead, a one-point gain for the Coalition since last October’s Freshwater poll. Primary votes were 39% Labor (up two), 37% Coalition (up two), 10% Greens (down one), 5% independents (steady) and 9% others (down three).

Liberal Premier Dominic Perrottet led Labor leader Chris Minns by 46-34 as preferred premier, reversing a 41-38 lead for Minns in October. On issue salience, cost of living was way ahead of any other issue. This poll was conducted February 23-25 from a sample of 1,247.

A Freshwater seat poll, reported by Bonham, of the safe Liberal seat of Pittwater, also for The Financial Review, had the Liberals leading independent challenger Jacqui Scruby by a 52-48 margin. Primary votes were 41% Liberals, 30% Scruby, 16% Labor, 4% Greens and 9% others. Seat polls are unreliable.

NSW Morgan poll: 52.5-47.5 to Labor

A NSW Morgan SMS poll, conducted February 24-28 from a sample of 981, gave Labor a 52.5-47.5 lead. Primary votes were 33.5% Labor, 32.5% Coalition, 11% Greens, 8.5% One Nation, 3.5% “teal independents”, 3% Animal Justice and 8% others.

One Nation is unlikely to contest most lower house seats. In seats they don’t contest, their voters are likely to benefit the Coalition. Bonham said the Coalition would benefit on preferences from the absence of One Nation candidates as NSW uses optional preferential voting, so a primary vote for One Nation may exhaust, but not one for the Coalition.

In forced choice questions, Perrottet had a 53-47 approval rating, but Minns led as better premier by 54-46. This poll should not be compared with the NSW January Morgan poll as that used a different methodology.

Tasmanian EMRS poll: Liberals retain lead

A Tasmanian EMRS poll, conducted February 14-19 from a sample of 1,000, gave the Liberals 42% (steady since November), Labor 30% (up one), the Greens 13% (down one) and all Others 15% (down one). Liberal incumbent Jeremy Rockliff led Labor’s Rebecca White by 44-36 as preferred premier (46-34 in November).

Tasmania does not use a single-member system for its lower house elections, so a two party vote is not applicable.

Read more https://theconversation.com/labor-slides-in-a-federal-newspoll-nsw-polls-give-labor-a-modest-lead-200734

When to Escalate a Debt Recovery Matter to Legal Action

Knowing when to transition from informal debt collection efforts to formal legal proceedings is a decision that many creditors find difficult to navigate. Acting too early can damage commercial relationships, while waiting too long can reduce the likelihood of recovery... Read more

Why Slurry Hose Systems Are Essential for Handling Abrasive Industrial Materials

Transporting abrasive mixtures is a common challenge in industries such as mining, dredging, and construction. These mixtures, known as slurry, consist of solid particles suspended in water or other liquids. Moving slurry through pipelines requires specialised equipment that can withstand... Read more

Why Choosing the Right Dental Clinic Matters for Long Term Oral Health

Maintaining good oral health requires regular checkups, preventive care, and professional treatment when needed. Visiting a trusted Dental Clinic plays a vital role in keeping teeth and gums healthy while preventing more serious dental problems in the future. Many people only... Read more

Is Deep Plane Facelift Safe in Thailand?

When you ask whether a deep plane facelift is safe in Thailand, you’re really asking: “Can I get high-quality surgical care with strong safety standards and reliable follow-up while I’m traveling?” That’s a smart question. But the country name alone... Read more

Why Cloud Services Are Now Essential for Business Growth and Security

In today’s fast-moving digital environment, understanding how cloud services support long-term stability has become a priority for businesses across Australia. As expectations shift and workplaces adopt more flexible models, organisations are turning to cloud services to keep systems running smoothly... Read more

Steel Cutting Services: Precision That Shapes Modern Construction

In today’s construction, manufacturing, and fabrication environments, steel cutting services play a vital role in turning raw steel into practical, usable components. From large-scale infrastructure projects to bespoke architectural features, the accuracy and quality of steel cutting directly influence the... Read more